![]() When 10 seconds is reached during the button press, the display will begin flashing double dashes. ![]() An otherwise unused decimal point on the display will illuminate while the button is depressed. The default username and password return to “admn". Note that outlet status (On/Off) is not affected by a factory reset. Allow about 3.5 minutes for the reset to complete. After releasing the button, the unit will initiate a factory reset. Press and hold the button for between 10 and 15 seconds. Utilizing an item such as a paper clip, you can depress the button. Q: How do I manually reset my Rack PDU back to factory defaults?Ī: Most PDUs have a small unlabeled button located behind a hole next to the LED displays or network port.What does this mean?Ī: The PDU is in overload condition above the maximum level the PDU can withstand. An overcurrent of one of the attached loads has occurred. What does this mean?Ī: Fuse Error or Breaker Error. Q: What do the 3 LED displays on my Rack PDU represent?Ī: They provide the amperage reading that each input line is conducting.Q: Will restarting the Sentry Power Manager (SPM) affect power on my Rack PDUs?.Q: Where can I find a list of available data cables and power cords?.Q: Where can I find the product manual for my Rack PDU?.This could result in an arc from the fuse causing a direct short to ground which can cause serious damage to the PDU and the operator.Ī: Visit the PDU Firmware Downloads section. Q: Is it ok to change a fuse while the Rack PDU is still plugged in?Ī: DO NOT attempt to change a fuse while the PDU is still plugged in.Q: What is the default user name and password?Ī: Both the user name and password are the string: admnĪ: The default IP address is 192.168.1.254.The intelligence and power of the PDU operate on two, separate circuits. ![]() Q: Will restarting my Rack PDU affect power to the outlets?Ī: No. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |